Product

KITCHEN FAUCET SHK0030

KITCHEN FAUCET SHK0030

The use of environmentally friendly products, especially products that come in direct contact with water sources such as shower, dishwashing faucet, etc., will help reduce the health risks. Son Ha premium shower is manufactured according to European technology and standards on the world’s most advanced technology line, helping to protect consumers’ health.

– Friendly and safe material for health

– Smart hot and cold valve

– Outstanding durability

– Luxury and high-class design

– 5-year warranty.

1,890,000₫

PRODUCT CHARACTERISTICS

OPERATING CONDITIONS

1. Water supply pressure: 0.05-0.75 Mpa

2. Test pressure: P = 1.75 Mpa

3. Input hot water temperature: t <85¬C

4. Ensure that water supply is clean, free from sand and gravel, impurities …

USER MANUAL

1. Move the handle to the right to start opening the water valve, to the left to close the water valve. When you want to use hot water, turn the handle towards the front of the faucet, and turn the handle behind the faucet to use cool water.

2. When adjusting the hot water temperature, turn the handle to the position of the cold water, then slowly turn towards the position hot water to adjust the hot water temperature accordingly. The handle can be rotated 360⁰ depending on the purpose of the user.

Note: When using hot water, the faucet body will be hot, and it is necessary to prevent children from contacting the faucet because it can cause burns to children.

PROBLEMS AND TROUBLESHOOTING

PROBLEM

REQUIRED INSPECTION

SOLUTION

Small flow

Water source valve is opened or not

Open the water source valve to increase gradually

There is any obstacle?

Open the nozzle, discharge cleanly waste with water or remove the obstacle

Water leakage

Control valve is loose or broken or not?

Tighten again the screw cover of control valve, or replace valve

Dirty handle

It is loose or not

Tighten screw to fix the handle

Hotline: 1800 6566
Service Center:
+ North: (+84) 4 62 65 65 86
+ South: (+84) 8 22 15 32 19

 

INSTALLATION INSTRUCTIONS

  1. Before installing, clean the inside of the water pipe by flushing water the inside of the pipe.
  2. Install washbasin faucet:
  • Drill holes in the floor or sink with size of Ø35Ø40mm, then pass the flexible hose into an external threaded pipe.
  • Next, tighten the flexible hose to the main body facing the front of faucet to install red flexible hose, the back of the faucet to install the blue flexible hose.
  • Insert the lower base, the outer threaded pipe into the main body, continue installing the plastic ring into the groove of the base.
  • When inserting a soft hose, an external threaded hose through the floor, take a plastic cover of the hose then tighten it, do not screw too tight to avoid causing the floor to crack or warp the basin.
  1. Connect the two flexible hoses on the main body with the water supply hose on the wall. The red flexible hose connects to the hot water supply pipe, the blue soft hose connects to the cold water pipe. At the ends of two flexible hoses, do not tighten by a wrench.

NOTES FOR INSTALLATION

1. The faucet has been rigorously tested at the laboratory during fabrication. Please do not arbitrarily open it.

2. After installation, check whether the joints are fully connected, if the pipe is leaking.

CÁC SẢN PHẨM LIÊN QUAN